E-33
ENGLISH
CD-G14000
CD-G17000
CD-G22000
2008/April/25 CD-G14000/17000/22000
Tape Playback
Listening to a cassette tape (TAPE 1 or TAPE 2)
Tape playback
Auto power on function:
When you press any of the following buttons, the unit turns on.
TAPE (1 2) button (main unit and remote control): The unit
turns on and the “TAPE” function is activated.
TAPE button on the remote control: The unit turns on and
playback of “TAPE” function starts.
/ button on the main unit: The unit turns on and playback of
the last function starts (CD, TAPE, TUNER, AUDIO IN).
Auto power off function:
In the stop mode of tape operation, the main unit enters the stand-
by mode after 15 minutes of inactivity.
Before playback:
For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not
recommended.)
Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
TIMER
POWER
ON/ STAND-BY
CD
TUNER
(BAND)
4
3
1
5
4
5
3
2
1
PRESET
TUNING
PRESET
TUNING
VOL.
VOL.
PHONES
RECORD/PLAYBACK
PLAYBACK (PLAY & STOP)
REMOTE
SENSOR
2
TAPE
(1 2)
OPEN/
CLOSE
c
AUDIO
IN
AUDIO
IN
1 Press the ON/STAND-BY button to turn the power on.
2 Open the cassette
compartment by pushing
the area marked “ ”.
3 Load a cassette into the
TAPE 1 compartment or
TAPE 2 compartment
with the side to be played
facing towards you.
4 Press the TAPE (1 2) button to select the cassette you
want to listen to.
5 Press the / (TAPE )
button to start playback.
Tape play indicator
C
D
4
3
2
1