04/1/28 CD-SW440N_09 EN
E-5
System connections
Cooling fan :
The main unit is built with a cooling fan at the rear of the unit for improved cooling. Please do not cover the opening of the
fan with any obstacles, as this will block proper ventilation.
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND terminals.
Position the AM loop aerial for optimum reception. Place
the AM loop aerial on a shelf, etc., or attach it to a stand or
a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
Connect the speaker light-up wires to the SPEAKERS
LIGHT-UP sockets for speaker illumination. To turn off the
speaker light-up feature, press the CLEAR/DIMMER
button on the remote control for 2 seconds or more.
Make sure to unplug the AC power lead before making any connections.
Right speaker
FM aerial
(not supplied)
(not supplied)
screws
wall
< Attaching to the wall >
< Assembling >
Wall socket (AC 220 - 240 V ~ 50/60 Hz)
Installing the AM loop aerial
Video cable
Black
Red
Left
speaker
AM loop aerial
To video
input
socket
TV
Left
speaker
light-up
wire
subwoofer
subwoofer
light-up wire
Right speaker light-up wire
Cooling fan
Aerial connection
Speaker light-up connection
●
Connect the black wire to the
minus (–) terminal, and the red
wire to the plus (+) terminal.
●
Do not make a mistake when
connecting the right and left
speakers. The right speaker is
the one on the right side when
you face the unit.
●
Do not let the bare speaker
wires touch each other.
Incorrect
●
Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
●
Do not stand or sit on the speakers. You may be
injured.
●
Never mistake the FRONT SPEAKERS and the
SUBWOOFER terminals. The unit or the speakers may
be damaged.
●
If you use other speakers with an impedance lower
than that specified, the unit may be damaged.
Front speakers: 4 ohms, Subwoofer: 8 ohms.
Speaker connection
To Next Page
Loading...
Need help?
General
