Sharp CP-SW1000W

E-9
ENGLISH
CP-SW1000W
Advanced Feature
Operating the TV with the remote
control
You can operate SHARP TV with this system’s remote control.
 Watching TV
Other operable button
Press the Input Select button to switch the input source. (TV)
Note:
Some models of SHARP TV may not be operable. In this case, use
the remote control supplied with each product.
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
 General
 Remote control
Point the remote control at the TV.
1 Press the TV POWER button to turn on the TV.
2 Press the CH UP or CH DOWN button to set the
channel.
Pressing the CH UP or CH DOWN button enables TV
channel switching.
3 Press TV VOL + or – button to adjust the TV volume.
TV operation buttons
Symptom Possible cause
No sound is heard.  Is the input signal (selection) set properly?
 Is the volume level set to “0”?
Noise is heard
during playback.
 Move the subwoofer away from any
computers or mobile phones.
When a button is
pressed, the unit
does not respond.
 Set this unit to the stand-by mode and
then turn it back on.
The power is not
turned on.
 Is the unit unplugged? (Refer to page 6)
 The protection circuit may be activated.
Unplug and plug in the power lead again
after 5 minutes or more.
Symptom Possible cause
The remote control
does not operate
properly.
 Is the battery polarity correct?
 Is the battery dead?
 Is the distance or angle incorrect?
 Are there any obstructions in front of the
subwoofer?
 Is there a strong light shining on the
remote sensor?
 Is the remote control for another
equipment used simultaneously?
The subwoofer
cannot be turned on
with the remote
control.
 Is the AC power lead of the subwoofer
plugged in?
 Is the battery inserted?
TV cannot be
operated with the
remote control.
 Depending on the model, some or all
functions may not be operable using the
remote control of this unit. In this case, use
the remote control supplied with the TV.