CP-SW1000W
Preparation for Use
Installation image:
Place the subwoofer as shown.
As the bass sound from the subwoofer is omni-directional, you
can place the subwoofer anywhere you like. However, it is
recommended to place it as close to the TV as possible.
The front panel of the subwoofer is not removable.
Do not change the installation direction when the subwoofer is
turned on.
Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
Do not stand or sit on the subwoofer as you may be injured.
Magnetically shielded speakers
The subwoofer can be placed near a TV set as the built-in speakers
are magnetically shielded. However, uneven colours may appear on
the screen depending on the type of TV.
If colour variation occurs.
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present.
Move the subwoofer further away from the TV.
Do not place the unit near any kind of magnet or an electromagnet
as irregular colours may appear on the TV screen.
Subwoofer connections to TVs
Turn off all other equipment before making any connections.
Refer to the operation manual of the equipment to be connected.
Fully insert the plugs to avoid fuzzy pictures or noises.
Caution:
Tuner receiving for other audio system
Placing the aerial near the subwoofer unit AC power lead may
cause noise pick up. Place the aerial away from the subwoofer
unit for better reception.
If the TV/monitor has an audio output, connect it to the AUDIO
INPUT sockets on the rear of the subwoofer.
VCR
DVD player
DVD playerVCR
TV
TV
To audio output sockets
Audio cable (supplied)
Subwoofer
To AUDIO
INPUT sockets
To Next Page
Loading...
