E-8
ENGLISH
CP-SW1000W
1
Basic Operation
General control
To turn the power on
Volume control
Main unit operation:
Turn volume knob clockwise to increase the volume and anti-
clockwise to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume and the VOL – button
to decrease the volume.
Note:
Do not turn the volume knob manually in reverse direction when
operating it by remote control.
Crossover frequency control
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasise the bass, turn this control towards 80 Hz and increase
the volume.
Notes:
Observe the following to avoid malfunction and sound distortion.
Do not set the volume too high on the audio system. The
subwoofer may be damaged.
Before you switch on/off the subwoofer, minimise the volume on
the audio system.
Auto power off
If no signal is detected for 20 minutes during power on, the
subwoofer will automatically go to stand-by mode.
Press the ON/STAND-BY button.
The volume indicator lights up
blue.
If the power does not turn on,
check whether the power lead is
plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button
again.
The STAND-BY indicator lights up
red.
(Lights
up blue)
(Turns red)
To Next Page
Loading...
