Instruction on control panel functions
Control panel / Display
6
WASH
RINSE
SPIN
NORMAL
JEANS
SPEEDY
DELICATE
BLANKET
TUB CLEAN
Wash heavy and very dirty clothing.
Wash speedy for Not-so-dirty clothing.
POWER
Course for cleaning washing / spin drying tub. Select the washing time: 2 hrs, 6 hrs, 9 hrs.
Caution
START/PAUSE
Press this key after turning on, selected course is started.
Plug the machine in and then press this key, the machine turns on.
Press this key again, it turns off.
1.If the machine is energized but not started, the power supply turns off automatically 5 min later.
2.If no key pressed after the START/PAUSE key is pressed during the running,
the power supply turns off automatically 10 min later.
Wash clothing with the HAND WASH mark.
Wash daily clothing like relatively
-dirty shirts or pants.
Wash strong for blankets or heavy clothing.
Select WASH as necessary. Select the washing time: [ - ] = 0 min ,1 min – 15 min.
Select RINSE as necessary. Select the rinsing time: [ - ] = 0 ,1 time – 3 times.
Select SPIN as necessary. Select the spinning time: [ - ] = 0 min ,1 min – 9
9
min.
BABYCARE
Wash gently and rinse thoroughly for baby clothing.
15
Common non-fault phenomenon (Please refer to this section
if you think an abnormality happens.)
Abnormal display
Presentation
U9
E4
E3
E2
E1
C2
Washing machine inclines
or is shaky.
The clothing is lopsided.
The end of drain hose is
blocked.
The drain position is
relatively high.
Top cover is not closed
during spin drying.
Possible non-fault cause
Coping process
Failure cause
Low flow at the faucet.
Water inlet filter net
is blocked.
It generates a beep when washing machine indicates abnormal display. If not connected in 10 min, it turns off
automatically. Because the phenomenon may not be a fault, please check it again before sending the machine
for repair. In the case of failure, please consult the maintenance department. Be sure not to disassemble and
repair the machine without permission.
Caution
List of failure cause
Water level sensor shows
an abnormal level.
Failure of water inlet
valve
Connector contact
failure
Wiring disconnection
Failure of safety switch
Failure of drain valve
Failure of drain valve
motor
Circuit failure
Get water in tube of
water level sensor
Connect failure on
drain valve motor
The faucet is closed.
Top cover is opened as the
reservation course starts.
Drain hose is folded/
crumpled/tied.
Inclease water supply, press
START / PAUSE key.
Turn the faucet on, press
START/PAUSE key.
Failure of water level
sensor
Clean filter net, press
START/PAUSE key.
Close top cover.
Adjust drain hose properly,
press START/PAUSE key.
Clean drain hose, press
START/PAUSE key.
Washing machine place the
horizontally with adjusting the
foots.
Distribute the clothing evenly.
Pull out the plug from the plug
seat, and entrust the main-
tenance department.
Top cover opened in the
situation of CHILD LOCK.
Turn the power off, and take it
from the top.
CHILDLOCK is not released,
unless you reset it manually.
Caution
[ - ] = 0 , 1
[ - ] = 0 ,1
[ - ] = 0 ,1
ECO
Water is saved by 1 time static rinse.