11
FV-DB2E
05/4/21 FVDB2E_UK.fm
TINSEA048SJZZ
DAB Operation
" Changing the station order
You can change the order of stations in the station list.
" Adjusting the DRC value
When the volume is low, adjust the DRC (Dynamic Range Control)
value to make the sound more audible (may not available for some
broadcast material).
1 Press the BAND button until "DAB" appears on the display.
2 Press the MENU button repeatedly to
select "Station order".
3 Within 30 seconds, press the ENTER
button.
4 Within 30 seconds, move the operation lever toward TUN-
ING UP or TUNING DOWN to select the desired station or-
der.
Alphanumeric:
All stations are displayed in alphanumeric order. This is the de-
fault setting.
Fav. station:
The 10 most recent stations appear as "Fav." and then appear
in alphanumeric order.
Active station:
The station list shows receivable stations and then others in al-
phanumeric order.
Multiplex:
Stations are sorted by frequency, in ascending order.
Trim stn. list:
Delete inactive stations from the list.
5 Within 30 seconds, press the ENTER
button.
1 Press the BAND button until "DAB" appears on the display.
2 Press the MENU button repeatedly to
select "Set DRC value".
3 Within 30 seconds, press the ENTER
button.
4 Within 30 seconds, move the operation
lever toward TUNING UP or TUNING
DOWN to select the desired DRC value.
DRC 1: Dynamic range is controlled as set for the broad-
cast. This is the default setting.
DRC 0: DRC is off.
DRC 1/2: Dynamic range is controlled half as much as the
level set for the broadcast.
5 Within 30 seconds, press the ENTER
button.
3
To Next Page
Loading...
