Sharp FV-DB2E - Maintenance; Specifications

23
FV-DB2E
05/4/21 FVDB2E_UK.fm
TINSEA048SJZZ
References
Maintenance
" Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
! Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
! Do not apply oil to the inside of unit as this may cause malfunc-
tions.
" Condensation
When condensation is formed, the unit may not function properly.
Condensation may form in the following cases:
! Shortly after turning on a heater.
! When the unit is placed in a room where there is excessive steam
or moisture.
! When the unit is moved from a cool place to a warm place.
To remove condensation:
Leave the unit for approximately 1 hour. The condensation should
evaporate and the unit will work properly.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
" General
" Radio
Type DAB receiver
Power source DC 9 V: AC adaptor (AC 230 - 240 V, 50 Hz)
DC 9 V: "C" size (LR14) alkaline battery 6
as main batteries
DC 3 V: "AA" size (UM/SUM-3, R6, or HP-7)
battery 2 as memory batteries
Power
consumption
11 W (AC adaptor)
7 W (DC, batteries)
Output power RMS: 4 W (2 W + 2 W) (10 % T.H.D.)
Speaker 8 cm full-range speaker
Output terminals Headphones:
3.5 mm stereo mini plug type 1
16 - 50 ohms (recommended: 32 ohms)
Line output (audio signal):
3.5 mm stereo mini plug type 1
2 V/10 k ohms at DAB 0 dB
Dimensions Width: 320 mm
Height: 135 mm
Depth: 100 mm
Weight 1.7 kg (without batteries)
Frequency range DAB: 174 - 240 MHz
FM: 87.5 - 108 MHz
6