Sharp HT-CN300W - Timer and Sleep Operation

32
HT-CN300W_A_4.fm02/7/11
HT-CN300W
Advanced Features
- Timer and sleep operation -
Timer and sleep operation
Timer operation is possible only when the tuner function is selected.
„
Setting the timer
Before setting timer:
Set the unit on time (page 22).
If it is not on time, you cannot use the timer function.
1
Press the ON/ (STAND-BY) button to turn the power on.
2
Press the TUNER/BAND button.
Tune in to the desired station. (See page 27.)
3
Adjust the volume using the VOLUME ( or ) button.
Do not turn the volume up too high.
4
Press the TIMER/SLEEP button repeatedly until " " is displayed.
5
Press the or button to specify the hour to start, then press the
ENTER button.
6
Press the or button to specify the minutes, then press the
ENTER button.
The unit will enter the timer stand-by mode automatically.