E-9
Controls and indicators (continued)
■ Remote control
92L1CT1012674A
1
2
3
9
5
6
7
8
10
11
12
4
1. STANDBY: Press this to switch on the unit. Press it
again to put the unit in standby mode.
2. VOLUME +: Press this to increase volume.
3. PREVIOUS: Press this to skip to the previous track.
4. PLAY/PAUSE: Press this to temporarily pause a
playback. Press it again to resume the playback.
Press and hold this button for 3 seconds to disconnect
Bluetooth connection.
5. VOLUME -: Press this to decrease volume.
6. BLUETOOTH: Press this to enter Bluetooth mode.
7. MOVIE: Press to enter the Eq2 equalizer mode MOVIE
(recommended for viewing movies).
8. MUSIC: Press to enter the Eq1 equalizer mode MUSIC
(recommended for listening to music).
9. MUTE: Press this to mute the sound. Press it again
to unmute.
10. NEXT: Press this to skip to the next track.
11. INPUT: Press repeatedly to switch among
BLUETOOTH, LINE IN, OPTICAL, ARC or USB mode.
12. NEWS: Press to enter the Eq3 equalizer mode that
is preset equalizers NEWS (recommended for viewing
news).
Caution:
● Replace all old batteries with new ones at the same
time.
● Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
● Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
● Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, re
or the like.
● Risk of re explosion if the battery is replaced by an
incorrect type.
Notes concerning use:
● Exposing the sensor on the unit and remote control to
strong light may interfere with operation. Change the
lighting or the direction of the unit if this occurs.
● Keep the remote control away from moisture, heat
shock, and vibrations.
Fitting or replacing the remote control battery
Use 2 “AAA” size batteries (UM/SUM-4, R3, HP-16 or similar).
1. Remove the batteries compartment cover on the back
of the remote control.
2. Load two AAA/1.5V batteries into the battery
compartment making sure that the battery have been
inserted with the correct polarities matching the symbols
+, - as indicated inside the battery compartment.
3. Replace the battery cover and clip it in place.
■ Battery installation
■ Remote control operation
● Point the remote control at the remote sensor on the
front panel.
● The remote control works within a distance of about 26
ft. (8 m) from the sensor and within an angle of about
30 degrees from the left and right side.
To Next Page
Loading...
Need help?
General
