Sharp HT-SBW110 User Manual

Remote control
1. – Switch the unit between ON and STANDBY mode.
2.
– Select the Bluetooth mode.
Press and hold to activate the pairing function in Bluetooth mode or
disconnect the existing paired Bluetooth device.
3.
– Select the play function.
4. VOL +/- – Increase/decrease the volume level.
5.
/ – Skip to previous/next track in Bluetooth mode.
6.
– Play/pause/resume playback in Bluetooth mode.
7.
– (MUTE) Mute or resume the sound.
8. BASS +/- – Adjust bass level.
9. TRE +/- – Adjust treble level.
10. EQ – Select a preset sound mode.
First time installation
Prepare the Remote Control
The provided Remote Control allows the unit to
be operated from a distance.
• Even if the Remote Control is operated within the e ective range of 6m,
remote control operation may be impossible if there are any obstacles
between the unit and the remote control.
• If the Remote Control is operated near other products which generate
infrared rays, or if other remote control devices using infra-red rays are
used near the unit, it may operate incorrectly. Conversely, the other
products may operate incorrectly.
Replace the Remote Control Battery
1. Press and slide the back cover to open the battery compartment of the
remote control.
2. Insert two AAA size batteries (included). Make sure the (+) and (–) ends
of the batteries match the (+) and (–) ends indicated in the battery
compartment.
3. Close the battery compartment cover.
Placement and Mounting
AB
A: Normal Placement (place Soundbar on leveled surface in front of TV)
B: Wall Mounting
Wall Mounting
NOTE:
 Installation must be carried out by quali ed personnel only. Incorrect
assembly can result in severe personal injury and property damage (if
you intend to install this product yourself, you must check for installa-
tions such as electrical wiring and plumbing that may be buried inside
the wall). It is the installer’s responsibility to verify that the wall will safely
support the total load of the unit and wall brackets.
 Additional tools (not included) are required for the installation.
 Do not overtighten screws.
 Keep this instruction manual for future reference.
 Use an electronic stud  nder to check the wall type before drilling and
mounting.
764mm
1
2
6

Sharp HT-SBW110 Specifications

General

RMS rated power	180 W
Audio output channels	2.1 channels
Audio Return Channel (ARC)	Yes
Receiver included	-
Bluetooth version	4.2
Connectivity technology	Wired & Wireless
Frequency range	60 - 20000 Hz
Certification	CE (EMC), CB (Safety), ErP (Energy)
Product color	Black
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Power consumption (standby)	0.5 W

Weight and Dimensions

Depth	60 mm
Width	800 mm
Soundbar weight	1300 g
Subwoofer depth	320 mm
Subwoofer width	150 mm
Subwoofer height	220 mm
Subwoofer weight	2700 g