E-12
CLEAN AIR & HUMIDIFY MODE
OPERATION
Use the Clean Air & Humidify Mode to quickly clean the air, reduce odors and to humidify.
1
Fill Water Tank. (See E-11)
Use the Clean Air Mode when additional humidity is not required.
About Automatic Humidify Mode
3
Press the FAN SPEED Button to select the
desired fan speed. (See E-13)
2
Press the CLEAN AIR & HUMIDIFY MODE
Button.
• If the power cord was not unplugged between uses, the
unit will automatically re-start at the previously selected
settings.
The Temperature/Humidity sensors automatically de-
tect and adjust humidity according to changes in room
temperature. Depending on the size and humidity of
the room, humidity may not reach 45 - 55 %. In such
cases, it is recommended that CLEAN AIR & HUMIDI-
FY/MAX MODE be used.
CLEAN AIR MODE
1
Press the CLEAN AIR MODE Button on the display
.
• If the power cord was not unplugged between uses, the
unit will automatically re-start at the previously selected
settings.
2
Press the FAN SPEED BUTTON to select the
desired fan speed. (See E-13)
Temperature Humidity
64 and below 55%
64-75 50%
75 and above 45%
Plasmacluster
ON/OFF Button
Power OFF
Button
Fan Speed
Button
Quick Clean MODE Button
Clean Air & Humidify MODE Button
Clean Air MODE Button
KC-850U_Eng.indd 12 10.4.14 10:35:08 AM
To Next Page
Loading...
Need help?
General
