To Next Page

To Previous Page

LC-26SA1E/RU, LC-32SA1E/RU

5 – 9

3) Windows Xp/2000 (“Setup_LptDrv_v020201_XP_2000.exe”).

After installing Visual I2C, the new generated file structure should look like this:

4. Check installation LPT driver using “C:\Program Files\Micronas\LptDrv\LptDrvTest.exe”. After run this software, if LPT driver is installed properly

must appear this screen:

• If the result is not OK, check inside PC bios: Parallel Port Mode=EPP

To run VCTp software update program, please click over “VCTP” icon from “START\All programs\Micronas\Visual I2C\IC\VCTP” and after Visual I2C

finish their starting process click on “TVT” module. As additional method, it’s possible to create a direct access to “C:\Program Files\Micronas\Visual

I2C\ic\vct6wxyP\vctq_tvt.vi2c” and launch it from Windows Desktop.