34
Power save settings
Go to “Menu” > “Setup” > “ECO”.
Setup
No signal off
ECO picture control
ECO
Energy save
CH list
:Exit:Enter
Menu
No operation off
[Disable]
[Disable]
[Off]
[On]
NOTE
• You can also select “ECO” by pressing ECO.
ECO
ECO picture control
This function automatically detects the image source and
decreases the power consumption while keeping the
brightness of the image unchanged.
NOTE
• This function does not work when “AV mode” is set to
“DYNAMIC (Fixed)”, “DYNAMIC” or “AUTO”.
• This function does not work when “Energy save” is set to
“Standard” or “Advanced”.
• This function is greyed out in 3D mode.
ECO
Energy save
This function enables you to reduce the backlight
brightness in order to decrease the power consumption
and increase the backlight life span as shown in the
following table.
Item
Standard
Reduces the backlight brightness.
Advanced
Reduces the backlight brightness more
than “Standard”.
Off
The backlight brightness is the same
value of your settings in the selected “AV
mode”.
When “Energy save” is set to “Standard” or “Advanced”,
“Energy save” status icons appear in the “Picture” menu
and channel information windows.
NOTE
• This function does not work when “AV mode” is set to
“DYNAMIC (Fixed)”.
• This function does not work when “3D brightness boost” is
set to “High” or “Low”.
ECO
No signal off
When set to “Enable”, the TV will automatically enter
standby mode if there is no signal input for 15 minutes.
NOTE
• Even if a TV programme finishes, this function may not
operate because of interference from other TV stations or
other signals.
ECO
No operation off
You can set the TV to automatically power off when no
TV operation is performed for 30 minutes or 3 hours.
NOTE
• “Disable” is the factory preset value.
ECO
Sleep timer
Allows you to set a time when the TV automatically
enters standby mode. You can set the time span for
entering standby mode after selecting “Change”.
NOTE
• Select “Off” to cancel the sleep timer.
• When the time has been set, countdown automatically starts.
• Five minutes before the preset of time expires, the remaining
time displays each minute.
ECO
Audio only
When listening to music from a music programme, you
can set the TV off and enjoy audio only.
Item
On
Audio is output without a screen image.
Off
Both screen images and audio are
output.
NOTE
• When you make operations that change the picture on the
TV such as by changing the input source, the “Audio only”
function is set to “Off”.
Basic adjustment
To Next Page
Loading...
Need help?
General