53
Connecting to the network
You can connect the TV to your Home network server
through a router or access point. The TV connection to
the router can either be wired or wireless.
NOTE
• If you choose a wired connection to the router, you need an
ETHERNET cable (commercially available).
• An Ethernet and wireless connection cannot be used at the
same time. Use only one of the connection types.
• A wireless LAN connection and performance cannot be
guaranteed for all residential environments. In the following
cases, the wireless LAN signal may be poor or drop, or the
connection speed may become slower.
− When used in buildings made with concrete, reinforced
steel, or metal
− When placed near objects that obstruct the signal
− When used with other wireless devices that emit the same
frequency
− When used in the vicinity of microwave ovens and other
devices that emit a magnetic field, electrostatic charge, or
electromagnetic interference
• A stable connection speed is required to play back streaming
content. Use an Ethernet connection if the wireless LAN
speed is unstable.
Wired installation
Use an ETHERNET cable to connect the ETHERNET
terminal on the TV to your broadcast router as shown
below. This is recommended when enjoying services
which require stable connection speeds, such as
streaming media.
E
Wired connection overview
PC (home network server)
Router (commercially available)
ETHERNET cable (commercially available)
E
How to connect
Router ETHERNET terminal
LAN
n
ETHERNET cable (commercially available)
1 Switch on the router (commercially available).
Refer to the router’s operation manual for
switching on.
2 Connect the ETHERNET terminal on the TV to the
router (commercially available) with an ETHERNET
cable (commercially available).
3 Go to “Menu” > “Setup” > “View setting” >
“Network setup” > “Connection type”.
4 Press c/d to select “Wired”, and then press
A.
5 Select “OK” to confirm.
Network setup
To Next Page
Loading...
Need help?
General