Sharp LC-60UF30H - Network Setting; Ethernet Network Connection; Wireless Network Connection; Add Network

26
Network function
Press
a
/
b
toselect“Ethernetnetwork
connection”, and then press ENTER.
Press
a
/
b
to select “Wireless network
connection”, and then press ENTER.
Select“Addnetwork”,andthenpress
ENTER. You can add unbroadcast wireless
network manually.
Press
a
/
b
toselectanavailablewireless
network , and then press ENTER.Ifthe
current network connection security is not
open, you should enter the password from
software keyboard by pressing ENTER on
theremotecontrol.Ifthenetworkconnection
security is open, you can connect it directly.
Select“Refresh”,andthenpressENTER, it
displays the “Wireless network list”.
1
1
1
3
2
2
2
Press
c
/
d
toadjust“Ethernet”to“On”.
Press
c
/
d
toadjust“Wi-Fi”to“On”,it
displays the nearly wireless network.
Entertheinformationabouttheunbroadcast
wirelessnetwork,andthenselect“Save”.Now
theTVisconnectedtotheunbroadcasted
wireless network.
Ethernet network connection
Wireless network connection
Add network
w
DHCP
w
Manual connection
Press
a
/
b
toselect“DHCP”.Press
c
/
d
to select
“On”.SystemwillattempttoobtainIPaddressand
other information automatically.
Press
a
/
b
toselect“DHCP”.Press
c
/
d
to select
“Off”.YoucansetupIPaddress,Gateway,Subnet
mask,FirstDNSandSecondDNSfollowingtheon-
screen instructions. After setting, press
a
/
b
to select
“Save”,andnowyoucanenjoytheinternetservices.
Select“Menu”inthesmarthome,andthenpress
ENTER. Press
a
/
b
toselect“Network”,andthen
press ENTER.Itdisplaystheconnectformat.
Network setting
NOTE
• YoucanpressMENUtoselect"Network"toswitchthe
connectionbetweenEthernetnetworkconnectionand
Wireless network connection.