66
Appendix
Removing the stand
For wall mounting with the optional bracket (AN-52AG4)
remove the stand.
Before setting TV on the wall
• Remove the connected cables (DVD, VCR, etc) from the
terminals.
• Before performing work, make sure to turn off the TV.
• Before performing work spread cushioning over the base area
to lay the TV on. This will prevent it from being damaged.
NOTE
• To attach the stand, perform the above steps in reverse order.
• As the TV is very heavy, be careful when moving it.
1 Unfasten the screws at the 4 locations on the rear
of the stand.
2 Detach the stand from the TV (hold the stand so it
will not drop from the edge of the base area).
To Next Page
Loading...
