Sharp LC-70UD1U - Page 36

LC-70UD1U
5 – 17
12. Software version
1. Main microprocessor
OKFK_UD1_xxx.USB
OKFK_UD1_xxx.DAT
OKFK_UD1_xxx_CHK.USB
OKFK_UD1_xxxxxxxx.PCC
2. Monitor microprocessor
OKFKMxxx.SMB
3. T-CON ROM
4. DRC/FRC Unit
CN3001/2 : LSE1_2Dxxxxxxxxxxxxxxxxx.E3D
CN3003 : LSE1_3Dxxxxxxxxxxxxxxxxx.E3D
CN3401/2 : LSE2_2Dxxxxxxxxxxxxxxxxx.ES2
CN5401 : LVMxxxxxxxxxxxxxxxxx.EVM
CN9003,9403 : PA168_Vxxxxxxxxxxxxxxxxx.FRC
13. Writing the inch and model name onto EEPROM
1. Enter the adjustment process mode.
2. Point the cursor to [MODEL NAME] (Page 29/29).
3. Select "UD1U”, and press [Enter] key.
4. "OK" is displayed.
5. Point the cursor to [PANEL SIZE] (Page 29/29).
6. Select "70" and press [Enter] key.
7. Moments later image is displayed.
8. Turn off power
9. Turn on power