Watching TV
Initial Installation (Continue)
CH Search (Channel search)
Channel auto search makes the TV look for all channels
viewable in the set area.
8 When "Air" is selected in Antenna setting:
Press / to select "Start", and then press ENTER.
When "Cable" is selected in Antenna setting:
Press / to select "Analog & Digital Search Start" to
search both analog and digital broadcasts, or to select
"Analog Search Start" to search only analog broadcasts,
and then press ENTER.
The Channel search will start automatically.
To exit the Channel search screen, select "Cancel", and
then press ENTER.
The Channel search results may include scrambled
channels or channels that are not viewable in the set area.
Press / to select "Yes", and then press ENTER to
remove scrambled channels.
Smart TV
When you connect to the Internet on the TV, select the
desired connection method and follow the instructions shown
on the display.
Wireless LAN connection is possible only when the WPS
(push button) method is used. If any other method is used,
make settings by Smart TV > Internet Setup > Internet
Connection. (See pages 9-2 to 9-4.)
9 Press / to select "Yes", and then press ENTER.
10 Press / to select "Wired" or "Wireless", and then press
ENTER.
ENG 2-5
To Next Page
Loading...
Need help?
General