Using a PC
Setting Audio Input
Audio Select
This function sets the terminal to output the computer audio.
The adjustment items vary depending on the input source. Select the input source corresponding to
the terminal connected to the PC and then adjust the desired item.
To perform the operation, refer to "Setup" > "Advanced" > "Audio Select".
PC IN
Video: Select this when the TV and PC are connected using an analog RGB cable and the audio is
not input.
Video+Audio: Select this when the TV and PC are connected using an analog RGB cable and the
audio is input via a Ø 3.5 mm stereo minijack.
HDMI(Digital): Select this when the TV and PC are connected using an HDMI-certified cable and
audio is input via the same cable.
HDMI+Analog: Select this when the TV and PC are connected using a DVI-HDMI conversion cable
and the audio is input via a Ø 3.5 mm stereo minijack.
NOTE
On the UD1U model, you cannot operate the "Audio Select" function during 4K60P signal input.
Operate this function during the input of other types of signals (such as Full HD).
When "Audio Select" is set to "HDMI(Digital)", sound will not be produced if you use only an
HDMI-certified cable to connect HDMI-compatible equipment. To produce sound, you should
make an analog audio connection.
If you want to connect HDMI-compatible equipment using only an HDMI-certified cable, set "Audio
Select" to "HDMI(Digital)".
ENG 8-2
To Next Page
Loading...
Need help?
General