Sharp MD-MS722H

■ Recording from a tuner or a CD (Manual recording)
● Manual recordings can be started and stopped as you like.
Recordings can not be made in the
following situations:
● Recording on a playback-only
MiniDisc (commercially available
music)
● If a Minidisc is protected against ac-
cidental erasure (page 10)
About the recording level:
● If the recording level is too low, the
playback sound volume may be too
low to hear well. If it is too high, the
playback sound may be greatly dis-
torted. Since digitally recorded CDs
have a large dynamic range (the vol-
ume can vary tremendously from
very soft to extremely loud), do not
set the recording level any higher
than is necessary.
Precautions when recording:
● Do not jar or bump the main unit
whilst recording. Otherwise, the re-
cording may be unusable.
● Depending on the strength and type
of playback signal in the original re-
cording, the new recording may not
begin or pause at the correct point
when in the synchro mode. If this
happens, try making a manual re-
cording.
Precautions when inserting a Mini-
Disc:
● To insert a Minidisc, push on the
middle of the edge of the disc whilst
holding it parallel to the main unit.
● If any resistance is felt, do not try to
force the MiniDisc into the unit. It
may cause more problems. If resis-
tance is felt, remove the MiniDisc
and try reloading it.
Note:
● Whenever any button is pressed, the
remote control display will light for
about 7 seconds.
1 Put the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the “Syn-
chro recording” section.)
2 Press the 06 button.
● Recording will start.
● To record from a CD, press the 06
button, and then start playback on the
equipment connected to this unit.
● Track numbers can be created whilst
recording. (Page 18)
To interrupt recording:
Press the 06 button whilst recording.
● The unit will enter the recording stand-
by mode.
● To resume recording, press the 06
button again.
The track number will be increased by
one each time you interrupt a record-
ing.
To stop recording:
Press the ■/:OFF button.
● If the unit is left alone after the record-
ing has stopped, the power will be
turned off about 2 minutes later.
After recording:
Press the ■/:OFF button whilst in the stop
mode.
● After the track number has been written
on the disc, the power will be turned off
automatically. (For details about the
TOC, see page 21.)
To remove the MiniDisc:
Turn off the power and move the EJECT
lever in the direction indicated by the
arrow.
12
MD-MS722H(SUK)