Sharp MD-MS722H

■ Recording from CDs or MDs (Synchro recording)
● Synchro recording is a method that detects the playback sound from the source
equipment. When sound is present, it automatically starts the recording. When the
source is silent, the recording will be paused.
1 Connect the external equipment.
(See page 9.)
2 Insert a recordable MiniDisc.
3 Press the ● REC button.
● To record from a tuner, first tune in a
broadcast.
● To record from a CD, first start playing
the track you want to record.
4 Whilst playing sound from external
equipment connected to this unit, move
the shuttle switch up or down to adjust
the recording level.
● Adjust the recording level so that the
maximum sound volume from the
source makes the reading swing some-
where between -4 dB and 0 dB.
● To record from a CD, first adjust the
recording level. Then put the equip-
ment connected to this unit into the
playback stand-by mode.
5 Press the ENTER/SYNC button.
6 Begin playback on the source equip-
ment.
● Recording will begin automatically.
To interrupt recording:
● When the source equipment is
stopped, the unit will enter the synchro
recording stand-by mode. When play-
back is resumed, a recording will be
resumed.
● If a silence lasts for 3 seconds or more,
the recording will be paused.
● Pressing the 06 button on this unit
(when in this mode) will cause the unit
to enter the recording stand-by mode
and cancel the synchro recording
mode.
RECORDING USING THE ANALOGUE CABLE
REC
ENTER
SYNC
0dB
-4dB
Flashing
11
MD-MS722H(SUK)