Sharp MD-MS722H

This is the method of recording digital signals from CDs or MDs exactly as they are stored
on the original. Compared to recordings made from analogue inputs, digital recordings
have extremely high-quality sound.
RECORDING USING THE OPTICAL DIGITAL CABLE
1 Connect the external equipment.
(See page 9.)
2 Start recording.
Synchro recording: Page 11
(1) Insert a recordable MiniDisc, and
then press the ● REC button.
(2) Press the ENTER/SYNC button.
(3) Start the playback on the equipment
connected to this unit.
Manual recording: Page 12
(1) Insert a recordable MiniDisc, and
then press the ● REC button.
(2) Press the 06 button.
● When recording from digital inputs,
it is not necessary to adjust the re-
cording level.
There are cases where digital
recording may be impossible.
In the following cases digital recording is
impossible, even if you are using digital
cables.
When you attempt to make a new digital
recording from a track that was digitally
recorded on a MiniDisc
● MiniDiscs are designed so that only
first generation digital copies can
made, further digital copies are pre-
vented by the SCMS (Serial Copy Man-
agement System).
Before starting a synchro recording,
perform the following steps on the
equipment connected to this unit.
(1) First, put it in the playback mode.
(2) Next, put it in the pause mode.
(3) Finally, position it at the beginning
of the track you want to record.
Recording
Playback
CD player, MD
player, etc.
Digitally recorded MiniDisc
Digital cable
Recording
Playback
Digital cable
Analogue recording is
possible.
Notes:
● This unit incorporates a sampling rate converter.
When this unit is connected to digital equipment such as CS/BS tuners or DAT tape
recorders that use a different sampling frequency (32 kHz or 48 kHz), recordings can
still be made. (The sampling frequency of this unit is 44.1 kHz.)
● When recording from a portable CD player, if it has a dropout prevention function, turn
that feature off.
13
MD-MS722H(SUK)