Sharp MD-MS722H

6 When a noise, such as a person speak-
ing, is picked up by the microphone,
recording will begin automatically.
● If a silence lasts for 3 seconds or more,
the recording will be paused automati-
cally. However, the unit will not pause
for about the first 10 seconds after re-
cording has started.
To interrupt a synchro recording:
Press the 06 button whilst recording.
● The Mic synchro recording mode will
be cancelled, and the unit will enter the
recording stand-by mode.
● To resume synchro recording, press
the ENTER/SYNC button again.
To stop recording:
Press the ■/:OFF button.
■ Recording from the microphone
(Mic manual recording)
● You can start recording manually (any
time you like).
1 Put the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the “Mic
synchro recording” section.)
2 Press the 06 button.
● Recording will start.
To interrupt a recording:
Press the 06 button whilst recording.
● The unit will enter the recording stand-
by mode.
● To resume recording, press the 06
button again.
The track number will be increased by
one each time you interrupt a record-
ing.
To stop recording:
Press the ■/:OFF button.
Notes:
● If you want to use a microphone, be sure it is a plug-in-power type microphone.
● When a plug-in-power type microphone is plugged in, the main unit will provide
power for the microphone’s operation.
● If a different type of microphone is plugged in, it may not operate properly or it may
cause the unit to malfunction.
● Insert the plug firmly. If you don’t, the recording will not be made properly.
● Use a microphone with a 3.5 mm (1/8") diameter stereo mini plug.
● When a recording is made using a stereo microphone (available separately), an
analogue recording will be made.
● Whilst making a mic recording, do not connect anything to the LINE IN socket on the
main unit.
15
MD-MS722H(SUK)