Sharp MD-MS722H

■ To erase tracks
To erase tracks one at a time:
1 Start playing the track you want to
erase, and press the 06 button.
● The unit will enter the pause mode.
2 Press the EDIT/MARK button and turn
the jog dial to select "ERASE".
3 Press the ENTER/SYNC button.
● To cancel the operation, press the
■/:OFF button.
4 Press the ENTER/SYNC button again.
● The track will be erased.
5 To erase other tracks, repeat steps 1 -
4.
To erase all of the tracks at once:
1 Whilst in the stop mode, press the
EDIT/MARK button and turn the jog dial
to select "ALL ERASE".
● “ALL ERASE” can also be selected by
holding down the EDIT/MARK button
for at least 2 seconds.
2 Press the ENTER/SYNC button.
● To cancel the operation, press the
■/:OFF button.
3 Press the ENTER/SYNC button again.
● All of the track numbers, track names,
and disc names will be erased.
Notes:
● Once a track has been erased, it can-
not be recovered. Double-check the
track number before erasing it.
● When a track is erased, the numbers
assigned to the tracks following the
erased track will be automatically de-
creased by one.
● When a track is erased, the track name
will be erased at the same time.
EDIT
MARK
ENTER
SYNC
Jog dial
1
2
1
Number of the
paused track
2
3
4
19
MD-MS722H(SUK)