Sharp MD-MS722H

5 When the letter you want is displayed,
move the shuttle switch up once.
● To enter more letters in the name, repeat
steps 3 - 5.
6 When the disc name has been completely
entered, press the ENTER/SYNC button
again.
If an incorrect letter is entered:
To erase a character:
Move the shuttle switch to move the cursor
to the character you want to erase. Then
press the BASS button.
To correct a character:
Move the shuttle switch to move the cursor
to the character you want to correct. Then
enter the correct character.
● Even after all the letters have been en-
tered, you can still go back and correct
any mistakes.
When you want to enter lowercase
letter:
Enter capital letters as described in step 4
and press the DISP button to change them
to the lowercase letters.
If you press this button again, the letters
will be changed back to capital letters.
To enter a space:
Move the shuttle switch to move the cursor
to the right. Then, press the DISP button
to enter a space.
■ Track name
Up to 100 characters can be entered for
each name.
1 Play the track which you want to name,
and press the 06 button.
● The unit will enter the pause mode.
2 Press the EDIT/MARK button and turn
the jog dial to select "Tr NAME".
● When "Tr NAME" is selected whilst in
the stop mode, the track numbers can
be selected using the jog dial.
3 Press the ENTER/SYNC button.
● The unit will enter the character input
mode.
● To cancel the operation, press the
■/:OFF button.
4 Perform steps 3 - 5 in the “Disc name”
section.
5 When the track name is completely en-
tered, press the ENTER/SYNC button
again.
1
Track number that you
want to give a track name
2
A C D E V W X Y Z
1 3 4 5 8 920
/ . ,
&
< >'
?! " #
_
`
;
– : ( )+
$
*
= @%
B
.
.
Capital letters
Symbols
Type of
characters
Characters <symbols>
(They are selected using the jog dial.)
Returns to
Returns to
indicates a space.
5
Position where the next
letter will be entered
6
Lights
up
31
MD-MS722H(SUK)