11
MAKING COPIES
USING THE AUTOMATIC DOCUMENT FEEDER TO
MAKE COPIES
This section explains how to make copies (1-sided copies of 1-sided originals) using the automatic document feeder.
1
Place the originals face up in the
document feeder tray with the edges
aligned evenly.
Place the originals face up. Insert the originals all the way into
the document feeder tray. The stack must not be higher than
the indicator line (no more than 100 sheets).
2
Make sure that the automatically
selected paper size is the same size as
the original.
The selected tray is highlighted. You can also copy onto paper
that is a different size than the original.
• Depending on the size of the placed original, there may be cases where the same size of paper as the original is not
selected automatically. In this event, change the paper size manually.
• To change the paper size selection, touch the [Job Detail Settings] key and then the [Paper Select] key, or touch the
paper size display (A).
The following screen appears when the [Paper Select] key or the paper size display (A) is touched. Touch the tray
key that has the desired paper size and then touch the [OK] key.
3
Check the colour mode.
The currently selected colour mode appears.
To change the colour mode, touch the [Colour Mode] key,
touch the [Full Colour] key, [Auto] key, [Single Colour] key or [2
Colour] key, and touch the [OK] key.
☞ COPY COLOUR MODES (page 21)
Full Colour: The original is copied in full colour.
Auto: Colour or black and white is automatically selected when
the original is scanned.
Single Colour: The original is copied in the selected colour only.
2 Colour: Only the red areas of the original are changed to the
selected colour; colours other than red are scanned
in black.
To Next Page
Loading...
