Sharp MX-2614N

TEST SIMULATION
SHARP
48
66
Fax Control Settings & Adjustments
13
Register dial number for Sim 66-14/15/16
14
Adjust/check the time dial pulse (10bps)
15
Adjust/check the time dial pulse (20bps)
16
Adjust/check the send level DTFM signal
17
DTFM signal to send to line (Max level)
18
DTFM signal to send to line (Soft Sw level)
21
Print various registration information
22
Set the sound volume of the handset
24
Fast memory data clear
29
Fax address book clear
30
Tel/LIU sensor status check
31
ON/OFF setting of output port (Tel/LIU)
32
Received data check (comparison)
33
Busy Tone/CNG/CED/FNET detect check
34
Display time required for sending test data
36
Check Send/Receive from modem.
39
Check Destination saved in Fax EEPROM
42
Rewrite PIC program installed on Fax box
43
Write program & adjustment values to PIC
installed on Fax
61
Display FAX related soft switch (151-250)
62
FAX receive data export in PDF format.
67
Printer Settings & Adjustments
17
Printer NVRAM clear
24
Printer half tone auto adjustment
25
Printer half tone colour adjustment
26
Standard target select of printer half tone
auto adjustment
27
Scanner target of printer calibration setup
(Service)
28
Standard target of printer colour
calibration (Service)
31
Printer calibration data clear
33
Printer screen gamma adjust. (PCL/PS)
34
Engine maximum adjustment mode for
printer
36
Adjust low density section
45
Printer image filter and trapping
adjustment.
52
Printer default gamma check (PCL/PS)
54
Printer colour balance adjustment