MX-FN10 EXTERNAL VIEWS AND INTERNAL STRUCTURES 4 – 5
(2) Motor and PWB
No. Code Signal Name Function
1 FEEDMOT1 FPTM1 Finisher Paper Transport Motor 1 Drives the inlet port roller and the feed roller.
2 FEEDMOT2 FPTM2 Finisher Paper Transport Motor 2 Drives the feed roller and the scrabbling belt.
3 GRPMOT FGM Finisher Gripper Motor Shifts the gripper arm in the exit/save direction.
4 ROMOT FDRLM Finisher Delivery Roller Lift Motor Drives the bundle exit roller up and down.
5 SIFTMOT FTLM Finisher Tray Lift Motor Drives the paper load tray up and down.
6 FJOGMOT FPAM-F Finisher Paper Alignment Motor F Drives the alignment guide on the front side.
7 RJOGMOT FPAM-R Finisher Paper Alignment Motor R Drives the alignment guide on the rear side.
8 BNDJOGMOT FSPAM Finisher Saddle Paper Alignment Motor Drives the saddle alignment guide.
9 RENDMOT FSPM Finisher Saddle Positioning Motor Drives the saddle folding position guide.
10 BNDR3MOT FSPTM Finisher Saddle Paper Transport Motor Drives No. 3 paper transport roller.
11 SLDMOT FSSM Finisher Stapler Shift Motor Shifts the stapler unit in the FR direction.
12 BNDBRDMOT FSDM Finisher Saddle Motor Drives the saddle folding plate.
13 LVLSOL FPHS1 Finisher Paper Holding Solenoid 1 Drives the lever for paper holding and detection of the paper surface in
the load tray.
14 PPRSSOL FPHS2 Finisher Paper Holding Solenoid 2 Holds paper in the process section.
15 Finisher Control PWB Controls the finisher.
16 BNDSTPLMOT FSM Finisher Staple Motor Drives the stapling mechanism. (Stapler unit built-in motor)
17 STPLMOT FSDSM Finisher Saddle Staple Motor Drives the stapling mechanism. (Stapler unit built-in motor)
13
7
6
8
4
1
2
14
3
15
11
16
17
5
10
9
12
To Next Page
Loading...