Sharp MX-M550N

MX-M700N DSPF SECTION C – 15
6) Open the DSPF, attach the DSPF drop preventing stopper,
and remove the paper guide.
7) Remove the earth, and remove the CIS.
[Note installing]
• When assembling the flat cable, first attach the lower side then
the upper side.
• Clean the paper guide glass surface.
E. Paper exit section
(1) DSPF paper exit motor
1) Remove the rear cover. (See “A-(1)-a. Cabinet”)
2) Remove the tension SP and remove the DSPF paper feed/
paper transport motor.
CIS cnt PWB
CIS unit
BLUE
No. Parts
Mainte
nance
(1) DSPF paper exit motor
(2) DSPF paper transport roller 3 brake clutch
(3) DSPF paper transport roller 3 clutch
(4) No.2 resist roller (Drive) ✕ {
(5) Paper exit roller (Drive) ✕ {
(6) DSPF document paper pass detector 3
(7) DSPF document paper pass detector 4
(8) DSPF paper exit detector
(9) DSPF open/close detector
(1)
(2)
(3)
(4)
(6)
(7)
(8)(9)
(5)