Auto Calibration
Auto Calibration
Performs automatic correction when the black copies is
off. The machine prints a test patch, the test patch is
scanned, and the black is automatically corrected.
After the [Execute] key is tapped and a test patch is
printed, a message appears prompting you to begin
automatic calibration. Place the test patch on the
document glass as shown below (so that the thin line at
the edge of the page is to the left).
Lay copy paper (about five sheets) that is the same size
as the test patch on top of the placed test patch, gently
close the automatic document feeder, and touch the
[Execute] key.
If the black is still off after performing Auto Calibration,
repeating Auto Calibration once again may improve
the black.
To Next Page
Loading...
Need help?
General
