Auto Calibration
Settings related to the printer function can be configured.
Performs automatic correction when the black copies is off.
The machine prints a test patch, the test patch is scanned, and the black is automatically corrected.
After the [Execute] key is tapped and a test patch is printed, a message appears prompting you to begin automatic
calibration.
Place the test patch on the document glass as shown below (so that the thin line at the edge of the page is to the left).
Lay copy paper (about five sheets) that is the same size as the test patch on top of the placed test patch, gently close
the automatic document feeder, and touch the [Execute] key.
If the black is still off after performing Auto Calibration, repeating Auto Calibration once again may improve the black.
To Next Page
Loading...
