Sharp MX-M753U

8-4
TROUBLESHOOTING
Contents
Making a copy of a non-standard size original
The procedure for making a copy of a payment slip or other non-standard size
original is explained below.
The "Centring" special mode of copy mode can be selected to position the copied
image in the centre of the paper.
FREQUENTLY ASKED QUESTIONS
X
Y
Or
igi
na
l
Si
ze Inpu
t
O
K
O
KCance
l
(25-432)
mm
200
150
(25-297)
mm
From the base screen of copy mode,
touch [Original] then [Size Input].
If the X dimension
(width) of the
document is less than
140 mm (5-1/2") or
the Y dimension
(height) is less than
131 mm (5-1/8"),
place the original on
the document glass.
For a thin original,
use "Slow Scan
Mode".
1 Place the originals. 2 Enter the original size.
Paper Select
Cancel
Plain
Pre-Punched
Heavy Paper
Pre-Printed
Colour
Transparency
Recycled
Thin Paper
Tab Paper
Letter Head
Labels
106 - 209 g/m2 (28 lbs.bond. - 110 lbs.index)
Bypass Tray Type/Size Setting
Select the paper type.
1
2
Paper Select
OK
3 Place paper in the bypass tray. 4 Select the bypass tray.
From the base screen of copy mode,
touch [Paper Select] and then "Bypass
tray paper type".
Type : Recycled
Size : A4
The bypass tray is used here to copy
onto paper that is not loaded in any of
the paper trays of the machine.