Replacing the cartridge in the saddle stitch finisher
Only when the saddle stitch finisher (MX-FN16) is installed.
7
Close the front cover of the finisher.
Make a test print or copy in the staple sort mode to verify that stapling is performed properly.
1
Open the lower cover of the saddle
stitch finisher.
When an optional inserter is installed, open the front cover of
the inserter before opening the lower cover of the finisher.
2
Slide out the saddle stitch unit carefully
toward the front.
3
(1) Grasp the grip of the saddle staple
holder and pull it out.
(2) While still grasping the grip, rotate
the saddle staple holder 90° in the
direction of the arrow (rotate to the
right).
4
Remove the empty staple case and set a
new one.
Replace both staple cases with new ones. Remove the cover
from the staple cartridge and then install the cartridge.
To Next Page
Loading...
