Sharp PG-D2500X User Manual

17
Easy Start
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page
48.)
2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3 After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the
Setup Guide.
4. Adjust the projected image with the Setup Guide
BP. 2 6
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
BP. 2 8
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode,
and use O/Q to select the audio input terminal.
On the
projector
On the remote
control
INPUT list
COMPUTER
INPUT Audio
S-VIDEO
S
VIDEO
V
On the
projector
On the remote
control
6. Select the Input mode
BP. 2 9
7. Turn the computer on
BP. 2 5
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On-screen display
On the
projector
On the remote
control

Sharp PG-D2500X Specifications

General

Brand	Sharp
Model	PG-D2500X
Category	Projector
Language	English