Sharp PN-465U - Page 22

PN-465U CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTION
2 – 13
(2) RS-232C command table
<How to read the command table>
Note: To specify the horizontal/vertical positions for vertical orientation, specify the values for horizontal orientation.
■ Power control/Input mode selection
■ SCREEN menu (PC2/PC3)
Command : Command field
Direction : W: When the “Parameter” is set in the parameter field, the command functions as described under “Control/Response Contents”.
R : The returned value indicated under “Reply” can be obtained by setting “????”, “ ?” or “???
+” (repeater control) in the parameter
field.
Parameter : Parameter field
Reply : Response (Returned value)
* : “Yes” indicates commands which can be used in power standby mode.
Function Command Direction Parameter Reply Control/Response contents *
POWER CONTROL POWR W 0 Switches to standby mode. o
1 Returns from standby mode.
R 0 Standby mode
1 Normal mode
2 Input signal waiting mode
INPUT MODE SELECTION INPS W 0 Toggle change for input mode
Terminals not selected in DVI SELECT/BNC
SELECT cannot be selected.
o
1 PC1 DIGITAL
“ERR” when AV (DIGITAL) is selected for DVI
SELECT.
2 PC2 ANALOG
3 AV2 COMPONENT
“ERR” when PC (ANALOG) is selected for BNC
SELECT.
4 AV3 VIDEO
6 PC3 ANALOG
“ERR” when AV (COMPONENT) is selected for BNC
SELECT.
7AV1 DIGITAL
“ERR” when PC (DIGITAL) is selected for DVI
SELECT.
R1PC1 DIGITAL
2 PC2 ANALOG
3 AV2 COMPONENT
4 AV3 VIDEO
6 PC3 ANALOG
7AV1 DIGITAL
Function Command
Direc-
tion
Parameter Reply Control/Response contents *
AUTO ASNC W 1
-
CLOCK CLCK WR 0-255 0-255 -
PHASE PHSE WR 0-63 0-63
POSITIONING PO SI TI O N OF
THE LONGEST
DIRECTION
HPOS WR 0-500 0-500 A maximum value depends on a resolution.
POSITION OF
THE SHORTEST
DIRECTION
VPOS WR 0-100 0-100
RESET ARST W 1
-