Sharp PN-465U - 5. POWER FILTER PWB REMOVAL; 6. TEMPERATURE SENSOR PWB REMOVAL; 7. OPTICAL SENSOR PWB REMOVAL; 8. Removal of the LCD unit

PN-465U DISASSEMBLY AND ASSEMBLY
3 – 2
5. POWER FILTER PWB REMOVAL
1) Disconnect the connector at 2 positions. Remove 4 screws , and
remove the power filter PWB.
6. TEMPERATURE SENSOR PWB REMOVAL
1) Disconnect the connector at 3 positions. Remove 6 screws , and
remove 3 temperature sensor PWB.
7. OPTICAL SENSOR PWB REMOVAL
1) Remove 2 screws , and remove the optical sensor PWB.
8. REMOVAL OF THE LCD UNIT
1) Remove four screws, and remove the connector panel unit.
2) Remove 12 screws, and remove the main frame.
3) Remove 16 screws, and remove two frame side assemblies.
Tem p1
Tem p2
Tem p3