26
E
Menu Items
■ OTHERS
AUDIO OUTPUT
For audio output that allows volume adjustment, select the internal speakers or the audio output terminal.
FIXED..............You can adjust the volume of the speakers. The volume of the audio output terminal is xed and cannot be
adjusted.
VARIABLE .......The speaker volume is muted and the volume of the audio output terminal can be adjusted.
INPUT SELECT
When INPUT4 input is selected, set AV component input or AV video input.
AUDIO SELECT (HDMI2)
Change the audio input of the HDMI2 input terminal to analog or HDMI.
COLOR SYSTEM (INPUT4, INPUT5)
Select the color system of the AV equipment which is connected to AV video input terminal. (AUTO / PAL / PAL-60 / SECAM /
NTSC3.58 / NTSC4.43)
When AUTO is selected, the color system is automatically set according to the input signal.
SCREEN (PC (INPUT6))
INPUT SIGNAL
When the D-sub input signal cannot be detected, manually set the resolution for the signal. Select 1280 x 768 or 1360 x 768.
AUTO SYNC.
CLOCK, PHASE, H-POS., and V-POS. are automatically adjusted using the currently input video signal.
Use this automatic adjustment when you use the D-sub to display a computer screen for the rst time or when you change
the setting of the computer. The automatically synchronized phase cannot be saved. If phase readjustment is needed, use
again this automatic adjustment.
H-POS.
Adjust the horizontal position of the image.
V-POS.
Adjust the vertical position of the image.
CLOCK
Adjusts frequency for sampling clock for applicable video.
Adjust when there is ickering in the form of vertical stripes.
When using the adjustment pattern (see page 27), make adjustments so that no vertical stripe noise appears in it.
PHASE
Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/or there are
ickers at corners. When using the adjustment pattern (see page 27), make adjustments so that no horizontal stripe noise
appears in it.
RESET
Resets the values of the SCREEN menu items to the factory default settings.
Do not reset the settings of the INPUT SIGNAL and AUTO SYNC..
SYSTEM UPDATE(SERVICE ONLY)
Used when updating the software. (For service technicians.)
To Next Page
Loading...
Need help?
General
