30
E
Controlling the Monitor with a computer (RS-232C)
RS-232C command table
How to read the command table
Command: Command eld (See page 29.)
Direction: W When the “Parameter” is set in the parameter eld (see page 29), the command functions as described
under “Control/Response Contents”.
R The returned value indicated under “Reply” can be obtained by setting “????”, “
?” or “???+”
(repeater control) in the parameter eld. (See page 29.)
Parameter: Parameter eld (See page 29.)
Reply: Response (Returned value)
* :
“○” : Indicates a command which can be used in standby mode or when the power is on.
“–” : Indicates a command which can be used when the power is on. Cannot be used in standby mode.
Power control/Input mode selection
Function
Command Direction
Parameter Reply Control/Response contents *
Power control POWR W 0
Switches to standby mode.
○
1 Returns from standby mode.
Input mode selection INPS W 0 Toggle change for input mode.
-
2 D-SUB
10 HDMI1
11 USB
13 HDMI2
25 TV
“Picture” menu
Function
Command Direction
Parameter Reply Control/Response contents *
Brightness VLMP WR 0-50 0-50
-
Wide mode (Screen size selection) WIDE WR 1-4 1-4 1: Wide, 2: Normal, 3: Dot by Dot, 4: Zoom
AV mode BMOD WR 0 0 Standard
2 2 Dynamic
5 5 PC
6 6 Movie
7 7 Game
8 8 Custom
User name USER WR XXXXXXXX XXXXXXXX 8 characters or less; half-width alphanumeric characters, “-”, and “_”.
(The eld can be left blank, but spaces cannot be entered.)
Password PASS WR XXXXXXXX XXXXXXXX 8 characters or less; half-width alphanumeric characters, “-”, and “_”.
(The eld can be left blank, but spaces cannot be entered.)
Model INF1 R Value
Serial no. SRNO R Value
To Next Page
Loading...
