17
Important
Follow the tips below to prevent cracks on the inner
surfaces and plastic components.
• Wipe out food oil adhered to plastic parts.
• Some household chemicals may cause damage, so use
RQO\GLOXWHGZDVKLQJXSOLTXLGVRDS\ZDWHU
• If undiluted detergent is used or soapy water is not
wiped off thoroughly, it may result in cracks of plastic
parts.
Cleaning
• 5HPRYHWKHDFFHVVRULHVHJVKHOYHVIURPWKHFDELQHW
and the door. Wash them by warm soapy dishwashing
water. After that, rinse them in clean water and dry.
• Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water thoroughly.
• Wipe the exterior with a soft cloth each time it gets dirty.
• Clean the magnetic door seal with a toothbrush and
warm soapy dishwashing water.
• Wipe the control panel with a dry cloth.
Note
• 'RQRWXVHKHDY\GXW\FOHDQVHUVRUVROYHQWVODFTXHU
paint, polishing powder, benzine, boiled water, etc.)
which may cause damages.
• If you pull out the power plug once, wait 5 minutes at
least before connecting the power plug again.
• The glass shelves weigh approximately 3 kg each. Hold
WKHP¿UPO\ZKHQUHPRYHIURPWKHFDELQHWDQGFDUU\
• Do not drop objects inside the refrigerator or strike the
inner wall. This may cause cracks to inner surface.
• The shaded parts in the picture below are unremovable.
Switching off your
refrigerator
,IWKHUHIULJHUDWRUQHHGVWREHVZLWFKHGRႇIRUDQ
extended period, the following steps should be taken to
UHGXFHWKHJURZWKRIPROG
1. Remove all food.
2. Remove the power plug from the socket.
3. Clean and dry the interior thoroughly.
.HHSDOOWKHGRRUVRSHQVOLJKWO\IRUDIHZGD\VWRGU\
Defrosting of the cooling unit
Defrosting is automatically operated by a unique energy
saving system.
When the compartment light
is blown
Contact the service agent approved by SHARP to
replace the light. The light is not to be replaced other
WKDQE\TXDOL¿HGVHUYLFHSHUVRQQHO
Care and cleaning
Unremovable
To Next Page
Loading...
Need help?
General
