SJGF60XT
36
EV-insulation A / EV-insulation B Assembly2.
• Attach the A-sealer EV. cover B and A-sealer EV. cover D.
• Fasten these parts with paper tape.
0～10
225
200
A-sealer EV. cover B
EV-insulation B
Ａ-sealer EV. cover B
A-sealer EV. cover B
A-sealer EV. cover B
EV-
insulation
A
EV-insulation B
A-sealer EV. cover D
A-sealer EV. cover D
EV-insulation B
EV-
insulation
A
EV-
insulation
B
Paper tape
Paper tape
Paper tape
Paper tape
Start of sealing
Paper tape
Paper tape
Overlapped
Overlapped
Apply tape along the edge.
Apply tape so that there is
no clearance between
EV-insulation A and B.
Start of sealing
Start of sealing
Apply tape along the edge.
Overlapped
Overlapped
Start of
sealing
Mounting the F-thermistor, fan motor F, and EV. insulation ass’y3.
• Fit the EV. insulation ass’y in the EV. cover.
• Wind the EV. cover sealer N on the F-thermistor.
• Mount the F-thermistor and fan motor F to the EV. cover.
EV-insulation ass’y
EV.cover sealer N
F-thermistor
EV.cover
Fan motor F
Apply the hook.
Wind the sealer on the lead wire,
and fit it in the rib.
Label is located on this side.
(Use caution about orientation.)
To Next Page
Loading...
