SJGF60XT
37
Mounting the fan louver4.
• Mount the DEF-thermistor, and fasten the harness of the fan motor F and the DEF-thermistor with the L-band C.
• Wind the EV. cover sealer N on the lead wire of the DEF-thermistor and the fan motor F.
• Apply the EV. cover AL.
• Mount the fan louvers A and B to the front, and fasten them with two screws.
• Attach the A-sealer EV. covers A, C and E as shown in the fi gure.
• Insert the pins into the connectors.
Fan louver A
EV.cover
Ａ-sealer EV. cover C
Ａ-sealer EV. cover E
Ａ-sealer EV. cover E
EV.cover
EV. cover AL
Ａ-sealer EV. cover A
Fan louver A
EV.cover
L-band C
EV.cover sealer N
DEF-thermistor
Fan motor F
Fan louver A
Fan louver B
Overlapped
Fan louver on
the back face
Overlapped
Apply the sealer to both
fan louver A and EV. cover.
Wind the sealer on the lead wire,
and fit it in the groove.
Cut out a surplus part.
Start of sealing
Overlapped
Viewed in direction of arrow A
Front view
Screw
Screw
Connector pin insertion specifications
Nos. 1, 2 and 3 connector pins
are already inserted.
Insert the lead wire
to the connector.
Blue
Blue
White
White
Fan motor F connector
DEF-thermistor lead wire
F-thermistor lead wire
Insert the lead wire
to the connector.
To Next Page
Loading...
