To Next Page

To Previous Page

SMD2470ASYSMD3070ASY

Fig. 1

1. Open the Drawer to access the (4) mounting screws holding the

unit on to the wall or cabinet opening. (Fig 1).

2. Close Drawer and carefully pull the unit out from opening and

unplug the power supply cord. Place unit on a secured surface

to work on.

3. Remove the (2) screws holding AC Cord Mounting

Angle. Lift the mounting angle (with AC Cord attached)

and unplug AC Cord from molex. (Fig 2).

4. Remove the (18) screws holding the Control Panel Rear Cover, Outer

Case/Side Angles, then remove outer Case. (Fig 2).

5. Remove the (10) screws holding the Back Plate.

NOTE: You now have access to all components of the Drawer.

WARNING: Follow all safety precautions as stated at the beginning of this Service

Manual before proceeding!

Fig. 2

MICROWAVE DRAWER DISASSEMBLY

Cavity

Back cover

Door Panel

Door

Frame

Assy

AC Cord

Mount Angle

AC Cord

Cord Bushing

Side Angle

Outer Case

Knockout

for Oven lamp

Replacement

Schematic Diagram

Side Angle

Latch Cover Plates

Sharp SMD3070ASY Service Manual

Other manuals for Sharp SMD3070ASY