If the connection is lost, follow the instructions above to pair your device to the player again.
Listen to Music from Bluetooth Device
If the connected Bluetooth device supports Advanced Audio Distribution Profile (A2DP), you can listen to the music stored on the
device through the soundbar’.
If the device also supports Audio Video Remote Control Profile (AVRCP), you can use the soundbar’s remote control to play music
stored on the device.
1. Pair your device with the player.
2. Play music via your device (if it supports A2DP).
3. Use supplied remote control to control play (if it supports AVRCP).
To pause/resume play, press the button on the remote control.
To skip to a track, press the buttons on the remote control.
Troubleshooting
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this unit, review the following
before requesting service.
No Power
Ensure that the AC cord is properly connected. Ensure that there is power at the AC outlet. Press standby button on the remote control or
soundbar to turn the soundbar on.
No Sound
Increase the volume. Press Volume Up on the remote control or on the right side of the soundbar. Press MUTE on the remote control to
ensure the soundbar is not muted. Press source buttons to select a different input source. When using either of the Digital input, if there is
no audio:
Try setting the TV output to PCM or
Connect directly to your Blu-ray/other source, some TVs do not pass through digital audio.
Your TV may be set to variable audio output. Confirm that the audio output setting is set to FIXED or STANDARD, not VARIABLE. Consult
your TV’s user manual for more detailed information. If using Bluetooth, ensure that the volume on your source device is turned up and
that the device is not muted.
Remote control does not work
Before you press any playback control button, first select the correct source. Reduce the distance between the remote control and the unit.
Insert the battery with its polarities (+/-) aligned as indicated. Replace the battery. Aim the remote control directly at the sensor on the front
of the unit.
I hear buzzing or humming
Ensure all cables and wires are securely connected. Connect a different source device (TV, Blu-ray player, etc) to see if the buzzing
persists. If it does not, the problem may be with the original device.
Connect your device to a different input on the soundbar.
I can’t find the Bluetooth name of this unit on my Bluetooth device
Ensure the Bluetooth function is activated on your Bluetooth device. Re-pair the unit with your Bluetooth device.
This is a 15 mins power off function, one of the ERPII standard requirement for saving power
When the unit’s external input signal level is too low, the unit will be turned off automatically in 15 minutes. Please increase the volume
level of your external device.
Technical specification
To Next Page
Loading...
