Sharp Soundbar 2.1

Pairing the Wireless Subwoofer with the Main Unit
Automatic Pairing
The subwoofer and soundbar will automatically pair when both units are plugged into the supply and turned on. No cable is needed for
connecting the two units. 
When the subwoofer is pairing with the main unit, the Pairing Indicator will flash fash. 
When the subwoofer is paired with the main unit, the Pairing Indicator will light up.
NOTE: 
Do not press the PAIR button on the rear of the subwoofer, except for manual pairing. 
If the automatic pairing fails, pair the subwoofer with the main unit manually.
Manual Pairing
1. Ensure that all the cables are well connected and the main unit is in Standby mode.
2. Press and hold the PAIR button on the rear of the subwoofer for a few seconds. The subwoofer will enter the pairing mode and the
Pairing Indicator will blink quickly.
3. Press the button on the main unit or on the remote control to switch the main unit on.
4. After the wireless connection succeeded, the Pairing Indicator will light up.
5. If the Pairing Indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer and then reconnect the main
cable after 3 minutes. Repeat step 1 ~ 4.
NOTE:
If the wireless connection fails again, check if there is conflict or strong
interference (for example, interference from an electronic device) around your location. Remove these conflicts or strong
interferences and repeat the above procedures.
The subwoofer should be within 6m of the soundbar in an open area.
If a device is connected via HDMI (CEC active), the main unit and the subwoofer will switch on automatically when the external
device is switched on.
If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator will flash. Follow step 1 ~ 4 above to
pair the subwoofer to the main unit.
Basic Operation
Standby/ON
When you first connect the unit to the main socket, the unit will be in STANDBY mode. The POWER indicator will light up red.
Press the button on the remote control to switch the main unit ON or OFF.
Disconnect the main plug from the main socket if you want to switch the unit off completely.
If a TV or an external device (Only for AUX socket) is connected, the unit will switch on automatically when the TV or the
external device is switched on.
When the unit has no input signal for over 15 minutes, it will automatically switch to Standby mode.
Select Modes
Press the SOURCE button on the unit repeatedly or press the AUX, BT (Bluetooth), OPTICAL, HDMI ARC buttons on the remote control to
select the desired mode.