16
Bluetooth mode
Ensure your radio is in Bluetooth mode by
short pressing
until the radio displays
<Bluetooth>. Your radio will begin to search for
Bluetooth devices. Ensure the Bluetooth-enabled
device you are connecting to is discoverable.
Note: If necessary, refer to the instructions for your
device to add or set up Bluetooth.
When found, your radio will be displayed as ‘SHARP
DR-P420’ on your device. Select this to begin pairing.
Once done, <BT connected> will be displayed on
your radio.
Paired devices will connect to the radio when they are
within range (within 10 metres in line of sight). Your
device will remain paired with the radio unless you
decide to disconnect it.
To disconnect from Bluetooth, long press
for
3 seconds to unpair your current device and search
for new devices.
Wirelessly stream music via Bluetooth
In Bluetooth mode, you can wirelessly stream audio
through the product’s speaker. Use the controls on
your paired Bluetooth device as well as those on your
radio. Controls available:
• Play/ Pause: Short press
• Previous track: Short press
• Next track: Short press
Volume can also be adjusted – either using your radio
and/or your connected device.
Note: If the radio is inactive for 20 minutes, or
no audio signal is being received, the radio will
automatically go into standby (or power o if the
radio is running on batteries).
To Next Page
Loading...
Need help?
General
