EN-10
START/STOP
SELECT AIR VOLUME
AND MODE
OPERATION
AUTO MODE
START STOP
NOTE
• When the product starts operation, the
operation starts in the previous mode it was
operated in.
NOTE
• When operating with humidifi cation ON in
the modes in the table below, the product
automatically controls humidity by sensing
temperature and humidity. (Except MAX / MED
/ LOW mode.)
Temperature
Humidity
ALL MODE
(Except MAX / MED /
LOW / SLEEP)
SLEEP
MODE
- 18 ºC 65 % 65 %
18 ºC - 24 ºC 60 % 65 %
24 ºC - 28 ºC 55 % 60 %
28 ºC - 45 % 50 %
HUMIDIFICATION
SETTING
ON OFF
POLLEN:
The Sensitive Dust Sensor sensitivity is
automatically increased and quickly detects
impurities such as dust and pollen and clean the air
powerfully.
SLEEP:
The product will operate quietly, and the fan speed
is automatically switched depending on the amount
of impurities in the air.
When the Light Control is set to “Auto”, Front
Display and Cleanliness Indicator automatically go
off. (Page 12, 13)
♪♪
♪♪♪ ♪
POLLEN SLEEP LOW MED MAX
The fan speed is automatically controlled
depending on the six detection. (PM2.5 / Usual dust
/ Odour / Temperature / Humidity / Light)
PLASMACLUSTER
ION SPOT MODE
Use this mode when you want to remove adhering
odour, germs, and other substances from clothes,
sofas and curtains.
Discharges stronger air with high-density
Plasmacluster ions only in the forward direction.
NOTE
• The Plasmacluster ion cannot be turned
“OFF”.
Adjust Front Louver manually.
To Next Page
Loading...
