Reports/Batch Commands
Page / 22
Designs and specifications are subject to change without notice.
05/2002
The UP-600 and UP-700 interface provides certain commands so the contents of the Data Tran
may be printed in a format allowing reconciliation between the POS terminal and the Data Tran
prior to executing the batch operations for closing the business day.
An important factor to keep in mind is which network provider is being used and the type of service
that is being provided. The results from issuing Inquiry commands will vary depending upon
whether the service provided is Host-based or Terminal based.
1. Report Command Functions:
The following command functions are provided;
1) Local Transaction Summary
2) Local Transaction Inquiry
3) Local Status
4) Batch Status
2. Typical Support (by type service):
x = not supported
o = supported
Note: the above chart indicates the typical scenario and may not hold true for all networks.
3. Related POS Reports:
The related POS reports that may be used to verify totals are as follows;
1) Transaction (X1/Z1)
2) Server/Cashier (X1/Z1)
Note: the examples in this document will use stand-alone reporting sequences.
OVERVIEW
noitcnuFdnammoCdesab-tsoHdesab-lanimreT
yrammuSlacoLXO
yriuqnIlacoLXO
)slatoT(sutatSlacoLOO
sutatShctaBOO
To Next Page
Loading...
