SECTION D - REPORTING
MOST TERMINALS ARE SHIPPED WITH AUTO REPORT KEYS (SHIFT X, SHIFT Z AND
SYSTEM Z). THEY COME PREPROGRAMMED TAKING SPECIFIC REPORTS, BUT MAY BE
MODIFIED. THE SYSTEM Z KEY WILL BE DISABLED ON SATELLITE TERMINALS.
THE FOLLOWING INSTRUCTIONS ARE FOR TAKING REPORTS WITHOUT USING THE
AUTO REPORT KEYS.
STAND ALONE TERMINALS
X REPORTS
(READING)
o TURN KEY TO “X1/Z1” POSITION
o TOUCH 1 “READING”
o TOUCH ENTER KEY
o SELECT REPORT YOU WISH TO PRINT
o TOUCH ENTER KEY
SOME REPORTS (PLU, DEPT) WILL REQUIRE A RANGE INPUT. EDIT THE
RANGE IF YOU WISH OR JUST PRESS THE ENTER KEY THROUGH THE
DEFAULTS.
o AFTER PRINTING PRESS CANCEL KEY TO RETURN TO MAIN REPORT
MENU
o TURN KEY TO “REG” POSITION
Z REPORTS (RESETTING)
o TURN KEY TO “X1/Z1” POSITION
o TOUCH 2 “RESETTING”
o TOUCH ENTER KEY
o SELECT REPORT YOU WISH TO PRINT
o TOUCH ENTER KEY
SOME REPORTS (PLU, DEPT) WILL REQUIRE A RANGE INPUT. EDIT THE
RANGE IF YOU WISH OR JUST PRESS THE ENTER KEY THROUGH THE
DEFAULTS.
o AFTER PRINTING PRESS CANCEL KEY TO RETURN TO MAIN REPORT
MENU
o TURN KEY TO “REG” POSITION
To Next Page
Loading...
