Sharp VC-H960U - Setting the Language; Setting the Clock

17
Dimensions: 257 ⳯ 182 mm
VC-A560U (17-21)
Setting the Language
When you use the VCR for the first time or the power is
interrupted for more than 5 seconds (power failure, etc.),
you should set the language to be used for the MENU
screen.
• Turn on your TV and select the video channel.
(See Setting the 3 ↔ 4 Output Channel.)
• Press POWER (POWER LED indicator will light up) and
then TV/VCR to select “VCR”. (VCR LED indicator will
light up.)
佡
! Press MENU.
LANGUAGE screen will appear.
@ Select the language with ∂/ƒ.
Ex.: ENGLISH
# Press SET to enter. To return to the normal screen, press
MENU.
ESPANOL
LANGUAGE
ENTER :SET EXIT :MENU
FRANÇAIS
SELECT :
ENGLISH
∂
ƒ
Normal
Screen
佡
Setting the Clock
Auto Clock Setting (If you DO know a channel that carries EDS signals)
• Make sure that the antenna cable is connected and connect the power cord.
• Turn on your TV and select the video channel. (See Setting the 3 ↔ 4 Output Channel.)
• Press POWER (POWER LED indicator will light up) and then TV/VCR to select “VCR”. (VCR LED indicator will
light up.)
ƒ
∂
MENU
©
ß
• If you press MENU to exit the LANGUAGE screen in Step #, the data will not be stored.
• You can also use the ∂ (CHANNEL ∂), ƒ (CHANNEL ƒ), © (FF è), ß (REW È), MENU or SET on the VCR to set the
On Screen Display (OSD).
(Remote Control)
! Press MENU.
Select “CLOCK” with ∂/ƒ and then press SET.
@ Select “AUTO” with ∂/ƒ and then press SET.
# Set EDS CH SET mode to “MANUAL” with ß/©
and then press ƒ.
MANUAL
CLOCK
AUTO
∂
ƒ
EDS CH SET AUTO MANUAL
EDS CH 02
AL
ß
©
佡
佡
ƒ
佡
∂
ƒ
佡
SET UP
MENU
ENTER :SET EXIT :MENU
CHANNEL PRESET
SELECT :
CLOCK
LANGUAGE
TIMER
IMPORTANT:
When using a cable box:
• See Cable TV Connections.
• Leave POWER on the cable box turned on and select a channel that carries EDS signals.
SET
佡